- Sand off scratches with P240 - P400. Subsequently clean and mask.
- Thinly apply 1K Plastic Adhesion Promoter.
- After drying, thinly apply 2K Acrylic Filler, then 3 spray processes with forced interim drying.
- After full hardening sand with P800 wet sandpaper first and then sand smooth with P1200.
- Roughen inner edge zone with grey ultra-fine abrasive pad, outer edge zone with sponge and Schleiffix.
- Dry and clean area.
- Apply a thin spray of 1K water-borne paint to a pre-warmed area (25-30°C) and continue with the normal painting process.
- When using barely opaque colour tones, after a corresponding flash time (matt stripped) it might be necessary to apply additional paint processes.
- Important: after each painting process, completely flash off the paint.
- Paint 2K Rapid Clear Coat in 2 complete paint processes with interim flash off time.
- Paint blender thinner / clear coat in light painting steps in all transition zones.
- If necessary, polish the transition zones after full hardening.
- SprayMax 2K Acrylic Filler (Part. No.: 680 036) guarantees optimum filling capacity, long-term resistance and the best possible substrate for the subsequent water-borne paint.
- With SprayMax 2K Rapid Clear Coat (Part. No.: 680 063), you get chip protected, resistant finishes.
- More than 50% process cost savings.
- Perfect painting results, just like with a spray gun.
- Matt stripping the painted areas can be accelerated by blowing with a hair dryer.
- Drying time at least 5 minutes.
¹ Varies depending on area and degree of soiling.
