- Smooth down irregularities with P100 - P240 and fill with Auto-K Universal Filler (Part. No.: 745 137).
- After full hardening with P100 – 240, sand smooth with dry sandpaper.
- Fill pores with Auto-K Combination Filler (Part. No.: 745 507).
- Fine sand with P400 dry sandpaper. Subsequently clean and mask.
- Thinly apply 2K Acrylic filler, then 3 spray coats with forced interim drying.
- After full hardening sand with P800 wet sandpaper first and then sand smooth with P1200.
- Roughen inner edge zone with grey ultra-fine abrasive pad, outer edge zone with sponge and Schleiffix.
- Dry and clean area.
- Apply a thin spray of 1K water-borne paint to a pre-warmed area (25-30°C) and continue with the normal painting process.
- When using barely opaque colour tones, after a corresponding flash off time (matt) it might be necessary to apply additional paint processes.
- Important: after each painting coats, completely flash off the paint.
- Paint 2K Rapid Clear Coat in 2 complete paint coats with interim flash off time.
- Paint blender thinner/clear coat in light painting steps in all transition zones.
- If necessary, polish the transition zones after full hardening.
- SprayMax 2K High-build Filler (Part. No.: 680 030) uniformly equalises irregularities.
- When used with SprayMax 2K Rapid Clear Coat (Part. No.: 680 063), you get the best finish qualities.
- About 50% process cost savings.
- Perfect painting results, just like with a spray gun.
- Matt stripping the painted areas can be accelerated by blowing with a hair dryer.
- Drying time at least 5 minutes.
¹ Varies depending on area and degree of soiling.
