- Roughen plastic section with ultra-fine grey abrasive pad and then let it dry.
- Clean the plastic part with silicone remover to partially dissolve the plastic.
- Then clean with Aqua Silicone Remover to reduce the electrostatic charge
- Thinly apply SprayMax Plastic Adhesion Promoter over the whole area.
- Apply a thin spray of 1K water-borne paint to a pre-warmed area (25-30°C) and continue with the normal painting process.
- When using barely opaque colour tones, after a corresponding flash time (matt stripped) it might be necessary to apply additional paint processes.
- Slightly nebulise the last spraying step.
- Important: after each painting process, completely flash off the paint.
- Paint 2K Rapid Clear Coat in 2 complete paint processes with interim flash off time.
- Small, uncoated spare parts such as mirror caps and bumpers can be optimally coated with SprayMax aerosol cans
- Optimal coating.
- More than 50% process cost savings.
- Perfect painting results, just like with a spray gun.
- Matt stripping the painted areas can be accelerated by blowing with a hair dryer.
- Drying time at least 5 minutes.
¹ Varies depending on area and degree of soiling.
