presto Contact Cleaner is a high-quality cleaner that ensures long-lasting conductivity for contacts.
For use on:
- Car and motorbike wiring and contacts
- Bicycles
- Print boards, electrical circuits, printing plates, contacts, plugs
- TV, radio, tools, stereos
Do not spray onto carburettors or coolers!
Quality and Properties
- Powerful cleaner without leaving a residue
- Removes dirt and oxidation
- Moisture repellent
- Corrosion protection
- Non corrosive
- Excellent adhesion
- Non conductive
- Powerful, directed jet spray
- This product has a special cap containing a tube and a spray head, which can be used to reach tricky places
- Sprayable from any angle due to a special 360° valve.
- TRG 300 compliant
Physical and Chemical Data
- Basis: Aliphatic Hydrocarbons with alcohol
- Colour: transparent
- Smell: characteristic
- Propellant: carbon dioxide
- Relative density at 20°C: 0.73 g/ml
- Yield: 3.8 g/sec.
- Refractive index at 20°C: 1.370
- Vapour pressure at 20°C: 5.5 - 6.5 bar
- Storage stability: 10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
- Size: aerosol can, maximum nominal volume 400 ml
Environment and Labelling
- Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
- Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
- Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using Instructions
- Before use, carefully read and observe the warning texts on the label!
Application:
- Bring can to room temperature.
- Operating temperature 5° to 30°C.
- Switch off electronic and electrical equipment before use so that there is no current at all.
- Shake for 2 minutes before use.
- Spray the parts to be cleaned with presto Contact Cleaner.
- After cleaning wait to all combustible solvent steam has disappeared (after 15 minutes at least).
- Only then turn on equipment.