Quality and properties
- A spray can pre-filled with propellants and specific additives. The water-based coat is transferred into the can by a filling device, producing a ready-to-use end product
- High coverage
- Simple, time-saving application
- Excellent atomisation
- Light blending
- Suitable for filling with all ColorMatic filling machines
- The dealer adds the desired coat colour and is, therefore, liable for the final product
Ideal for spot repairs
Physical and chemical data
-
Colour: depending on filling
-
Smell: solvent
-
Degree of gloss: it is necessary to re-coat basecoats with 2K clear coat. After the varnishing with clear coat the basecoat is featured with an excellent weather- and chemical resistance and a everlasting gloss.
-
Efficiency:
Depending of consistence and colour of the substrate
-
Substrate:
Depending on the colour of the substrate apply Primer Filler HG1 - HG8, ColorMatic Plastic Primer, ColorMatic 1K Primer for Alu, ColorMatic 1K Primer for Zinc, ColorMatic 1K Epoxy Primer, ColorMatic 1K Filler, ColorMatic 2K Hi-Speed Primer Filler.
-
Drying (at 20°C, 50% relative air humidity):
The drying time depends on the ambient temperature, the air humidity, the applied paint thickness and the filled type of paint (refer to information of the paint manufacturer)
-
Storage: empty cans: 5 years
Filled cans: WB-A to WB-F, WB-H: within one week
WB-G: within 4 days.
WB-I: within 3 days, depending on colour up to 10 days
If appropriate storage provided (=10°-25°C, relative air humidity max. 60%)
-
Size:
Aerosol cans, maximum nominal volume 400 ml, filling quantity 100ml
-
VOC-value: 216g
Environment and labelling
Environmentally sound: The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal: Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling: All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using instructions
Before use, carefully read and observe the warning texts on the label!
- Pre-treat undercoat with a basecoat as usual and clean with ColorMatic silicone cleaner no. 174469
- Shake can vigorously for 2 minutes
- Carry out spray tests
- Base cats must be coated with ColorMatic 2K hi-speed clear coat gloss no. 187216, or satin no. 231650
- Surface can be re-coated after 30 min drying-time
2-3 full coats, 50µ
- Leave to dry for 2 minutes between coats
-
For professional use only
- Wear an appropriate respirator (recommended type A2/P3)
