SprayMax 2K KTL refinish
2-component primer for the quick and easy isolation of loop-through or other imperfections in a black cathodic dip priming.
In color and gloss level to common KTL types matched, such as BASF Carthoguard CG 570 and 580. For treating fresh dip coating, without intermediate sanding.
KTL coatings are more than three days to grind.
Benefits
-
Very good adhesion on black KTL
-
Very fine atomization with minimal overspray
-
Heat resistant (200 ° / 25min)
- Recoatable with powder coatings
Technical Information
Application
Insulation of sanded-through spots or other imperfections in a black cathodic dip priming
Substrates
KTL-coated metals
Pretreatment
-
KTL paint that are older than three days should be sanded before mending with SprayMax 2K KTL refinish.
-
Shake can before triggering 2 min thoroughly
-
Remove the red push button from the cap. Turn aerosol by 180 ° and attach button to pin in the can bottom
-
Turn the can with the cap upside down on solid ground. Press red button with the palm of your hand until it stops
- Shake after triggering again thoroughly 2 min thoroughly
Spray coating
-
1-2 spraying operations. 5 min intermediate flash-off time between 2 coats.
-
Spraying distance: 15-20 cm
- Drying times: The following drying times refer to an ambient temperature of 20 ° C and a dry film thickness of 40 microns
Dust dry: (drying step 1 in accordance with DIN 53150) 4 min,
To handle: (Dry Stage 3 in accordance with DIN 53150) 17 min
Further processing
Overpainting The planned construction in the painting result. Even with powder coatings
Processing time
about 6.5 hours at 20 ° room temperature
Notes
To be used by the expert. Personal protective equipment should be worn respirator type: A2 / P2 Protective gloves, eg latex or nitrile. After finishing the painting, reverse aerosol and spray valve empty. The completely empty spray cans as recyclable material disposed of usability of the unfired Dose 36 Months
Labelling according to Regulation (EC) No 1272/2008:
General notes:
(P101) If medical advice is needed, have product container or label at hand. (P102) Keep out of reach of children. (P103) Read label before use. (P210) Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. (P211) Do not spray on an open flame or other ignition source. (P251) Do not pierce or burn, aven after use. (P261) Avoid breathing dust/fume/gas/mist/vapours/spray. (P273) Avoid release to the environment. (P302) IF ON SKIN: (P352) Wash with plenty of water. (P305) IF IN EYES:(P351) Rinse cautiously with water for several minutes. (P338) Remove contact lenses, if present and easy to do. Continue rinsing. (P333) If skin irritation or rash occurs:(P313) Get medical advice/attention. (P337) If eye irritation persists:(P313) Get medical advice/attention. (P410) Protect from sunlight. (P412) Do not expose to temperatures exceeding 50°C/122°F. (P501) Dispose of contents/container to …
Hazard statements:
(H222) Extremely flammable aerosol. (H229) Pressurised container: May burst if heated. (H315) Causes skin irritation. (H319) Causes serious eye irritation. (H317) May cause an allergic skin reaction. (H412) Harmful to aquatic life with long lasting effects.
Hazard pictograms:
Signalword: Danger