Quality and properties
- 1K primer filler with very good corrosion protection properties
- Filler and primer at the same time
- For isolation of sanded surfaces
- Short drying time
- Very good flow
- Weldable
- Recoat with ColorMatic water-and solvent-based paints as well as 1K and 2K topcoats
Physical and chemical data
- Basis of binder: polyvinyl butyral
- Smell: s. order information
- Smell: solvent
- Efficiency:
Depending on consistence and colour of the ground: 400 ml are sufficient for approx. 1,0 m²
- Substrate:
Bare sanded through areas in 2 K filler or 2 K old paints, putty spots sanded and cleaned, roughened and cleaned factory prime coats, roughened and cleaned factory or old paint jobs and can also be used on nearly all plastics.
- Drying time (at 20°C, 50% relative air humidity):
30-40 minutes
The drying time depends on surrounding temperature, air humidity and thickness of the applied coat
- Temperature restistance: to 250°C
- Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
- Size: Aerosol cans, maximum nominal volume 400 ml
- VOC-value: 168,6g
Environment and labelling
Environmentally sound:
The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal:
Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling:
All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using instructions
Before use, carefully read and observe the warning texts on the label!
- Remove all rust from damaged area, clean the surface thoroughly and sand
- Damaged area must be dry and free of dust and grease
- Clean undercoat with ColorMatic silicone remover no. 174 469
- Shake the can well for 2 minutes
- Carry out spray test
- Do not overcoat with polyester products
For professional use only
Wear an appropriate respirator (recommended type A2/P3)