Quality and properties
- Excellent adhesion and corrosion protection for steel, galvanized steel, aluminium and fibreglass
- Simple, time-saving application
- Fast drying
- Good flow
- Recoat with ColorMatic pre-fill base paints and RAL-acrylic topcoats
- Good insulation against moisture
- Wet-on-wet application possible
Physical and chemical data
- Basis of binder: Epoxy resin
- Colour: grey
- Smell: solvent
- Efficiency: 1 m²
Substrate:
blank metal sanded, zinc coated cleaned and sanded, aluminium, enodized aluminium, old paints cleaned and sanded, glass fiber materials cleaned and sanded, plastic substrates first priming with ColorMatic 1K Plastic Adhesive
- Temperature resistance: to 90 °C
- Storage stability:
10 years if appropriate storage provided (=10°-25°C, relative air humidity of max. 60%)
- Size:
Aerosol cans, maximum nominal volume 400ml
- VOC value: 274,5g
Environment and labelling
Environmentally sound:
The products of MOTIP DUPLI are 100% free of heavy metals. The caps and packagings are made of recyclable material.
Disposal:
Only the completely emptied cans should be put into the recycling skip or appropriate container for reclaimable refuse. Cans which are not empty should be disposed off as "special refuse".
Marking/Labelling:
All products made by MOTIP DUPLI comply with the actual labelling regulations according to Preparation Guideline 1999/45/EG. All aerosols correspond to TRGS 200 and TRG 300 as well as to aerosol guideline 75/324/EWG in the actually valid version.
Using instructions
Before use, carefully read and observe the warning texts on the label!
Application
- Remove all rust from metal surfaces
- Clean surface with ColorMatic silicone remover no. 174469, then sand
- Clean glassfibre surfaces with ColorMatic Plastic Cleaner antistatic no. 190261
- Shake the can well for 2 minutes
- Carry out test spray
- Damaged area must be free of grease, dust and dry
- For professional use only
- Wear an appropriate respirator (recommended type A2/P3)