ApplicationHigh-quality, pull-off sprayable film with grip effect for indoor and outdoor use. For protection, decoration and design. Resistant to abrasion, car washes and chip impact. Suitable for all smooth, non-absorbent surfaces of metal and plastic, e.g. rims, attachments, bicycles, skateboards, laptops, tools and decorative objects. Surfaces must be resistant to solvents, clean and dry. Check compatibility with the undersurface before use. Shake the can vigorously for 2 min. before use and carry out a test spray. For easy removal, apply approx. 5 coats. For neon colours and blue, apply 2 coats of white to give the full luminosity. Pre-paint wood with a clearcoat to achieve a smooth surface.
Advantages
- Protection and insolation
- Perfect for rims and bodywork
- Abrasion and stone chip resistant
- Für car, house, handcraft and hobby
- Fast drying (45 min. dust dry)
- For indoors and outdoors
- High tearing-strengh when removing (after 2 hours)
Binding agent base
Snythetic rubber (SBR)
Spray applicationSpray distance: 10 – 20 cm
To ensure easy removal, apply approx. five spray passes (approx. 80-100µm dry layer thickness).
Observe a 5 - 10 minute flash-off time
For application the Neon colours and brillant-blue a white primer (Liquid Gum white, prod. No. 233 251) is required to achieve the glow effect
Drying timesDust dry 45 min
Ready for mounting 90 min
Waterproof / rainproof: 2 h
Can be removed after: 2 h
Can be topcoated 2 h
Can be topcoatedWith itself: after drying (observe flash-off time)
Once fully dried (approx. 2h) Liquid Gum can be topcoated with Auto-K / belton spray aerosols. Apply max. 3 spray passes. More topcoats make it difficult to peel-off
Layer structureSpray about 5 even, closed, thin layers to ensure that an adequate layer of fi lm is created. Observe a fl ash-off time of 5 - 10 minutes between the separate layers
No full hiding is achieved after 2-3 spray passes because the product acts similar to a stain. Minimum 5 spray passes are required to achieve full hiding as well as the full tensile strength required for the peel-off procedure
Important: Always remove the masking tape as long as the last layer is still wet; otherwise there is a risk the edges will rupture
Note: Attention! Do not use products containing solvents, e.g. degreaser (petroleum benzine)
